Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Necking 30-06 to 25-06 results in blown primer
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mike Matteson" data-source="post: 2185429" data-attributes="member: 101791"><p>I haven't had any problem with sizing 30/06 or 270 brass to 25/06. Sizing down if I remember correctly doesn't create a donut. (I could be wrong) If expanding the neck does create the donut. Somebody will add to this. The neck turning should be done before sizing down if going to be done. At the time in using other calibers to size to 25/06 I didn't cut necks. Case length will grow and that need to be watch all the time. I had a problem with one of my 25/06 years back. It was because of overall case length was to long. It will make it appear that high pressure from powder loads was to much, but it's case length. The neck being stuck in the chamber just a bit. Never had that problem again by checking my case length and keeping them trimmed. I am just about to pull the trigger on a Tri Trim Gen 3. Going to trim each time after firing the case. Another step I have or adding to my reloading.</p></blockquote><p></p>
[QUOTE="Mike Matteson, post: 2185429, member: 101791"] I haven't had any problem with sizing 30/06 or 270 brass to 25/06. Sizing down if I remember correctly doesn't create a donut. (I could be wrong) If expanding the neck does create the donut. Somebody will add to this. The neck turning should be done before sizing down if going to be done. At the time in using other calibers to size to 25/06 I didn't cut necks. Case length will grow and that need to be watch all the time. I had a problem with one of my 25/06 years back. It was because of overall case length was to long. It will make it appear that high pressure from powder loads was to much, but it's case length. The neck being stuck in the chamber just a bit. Never had that problem again by checking my case length and keeping them trimmed. I am just about to pull the trigger on a Tri Trim Gen 3. Going to trim each time after firing the case. Another step I have or adding to my reloading. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Necking 30-06 to 25-06 results in blown primer
Top