Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
The Basics, Starting Out
Neck turning???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BrentM" data-source="post: 1915437" data-attributes="member: 61747"><p>A couple of thousands is a lot for what you are doing. It's hard to measure unless you have very high end calipers or micrometer to measure neck thickness. I'd trim the cases to the shortest length and set your neck turning depth to kiss the shoulder. I'd start with the cutter just barely skimming the surface and run 5 cases. One of the five will likely have a very obvious neck wall divot and I'd plan to clean that case to 95%. I'd rerun the other 4 and would expect .005 removal with a total of about .001 off the outside diameter.</p></blockquote><p></p>
[QUOTE="BrentM, post: 1915437, member: 61747"] A couple of thousands is a lot for what you are doing. It's hard to measure unless you have very high end calipers or micrometer to measure neck thickness. I'd trim the cases to the shortest length and set your neck turning depth to kiss the shoulder. I'd start with the cutter just barely skimming the surface and run 5 cases. One of the five will likely have a very obvious neck wall divot and I'd plan to clean that case to 95%. I'd rerun the other 4 and would expect .005 removal with a total of about .001 off the outside diameter. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
The Basics, Starting Out
Neck turning???
Top