Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning, sizing die, and neck tension?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ThrdKllr" data-source="post: 1682390" data-attributes="member: 110734"><p>The cutter on the neck turn tool needs to have the same angle or slightly less than the angle of the shoulder on your brass. When turning just kiss the shoulder (a sixteenth or less). This prevents the dreaded donuts. Full length size, run it over an expander mandrel .001 larger than your turning mandrel and lube the necks. It works better to cut in small increments and recut to get to the dimensions you want.</p></blockquote><p></p>
[QUOTE="ThrdKllr, post: 1682390, member: 110734"] The cutter on the neck turn tool needs to have the same angle or slightly less than the angle of the shoulder on your brass. When turning just kiss the shoulder (a sixteenth or less). This prevents the dreaded donuts. Full length size, run it over an expander mandrel .001 larger than your turning mandrel and lube the necks. It works better to cut in small increments and recut to get to the dimensions you want. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning, sizing die, and neck tension?
Top