Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning, sizing die, and neck tension?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="misterc01" data-source="post: 1681574" data-attributes="member: 109160"><p>I measure the neck thickness with an RCBS Vernier Ball Micrometer.If the measurements the same at three points around the neck I leave as is. IF not. I clean it up to get to even measurement around the neck. Then use the correct busing and size for .002 thousandths neck tension. Neck turning is a one-time process. same for primer pocket uniforming, deburr, etc. New brass is easiest, fired brass I FL resize to start with a standard case.</p></blockquote><p></p>
[QUOTE="misterc01, post: 1681574, member: 109160"] I measure the neck thickness with an RCBS Vernier Ball Micrometer.If the measurements the same at three points around the neck I leave as is. IF not. I clean it up to get to even measurement around the neck. Then use the correct busing and size for .002 thousandths neck tension. Neck turning is a one-time process. same for primer pocket uniforming, deburr, etc. New brass is easiest, fired brass I FL resize to start with a standard case. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning, sizing die, and neck tension?
Top