Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning on a lathe
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="birdiemc" data-source="post: 1817267" data-attributes="member: 29632"><p>Turning some necks today so I thought I would share my setup.</p><p>I pulled the ram from my lee handheld press. Looped that on a j bolt held by a chuck in the tailstock.</p><p>I turned down a mandrel with a shoulder to stop the brass forward movement, but the cutting tool clears it.</p><p>Use the ram in the tailstock to press the case onto the mandrel, then use it again to pull it back off.[ATTACH=full]171550[/ATTACH][ATTACH=full]171551[/ATTACH][ATTACH=full]171552[/ATTACH][ATTACH=full]171553[/ATTACH]</p></blockquote><p></p>
[QUOTE="birdiemc, post: 1817267, member: 29632"] Turning some necks today so I thought I would share my setup. I pulled the ram from my lee handheld press. Looped that on a j bolt held by a chuck in the tailstock. I turned down a mandrel with a shoulder to stop the brass forward movement, but the cutting tool clears it. Use the ram in the tailstock to press the case onto the mandrel, then use it again to pull it back off.[ATTACH type="full"]171550[/ATTACH][ATTACH type="full"]171551[/ATTACH][ATTACH type="full"]171552[/ATTACH][ATTACH type="full"]171553[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning on a lathe
Top