Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning.. fast vs slow, does it matter?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Deleted member 46119" data-source="post: 992113"><p>A machinist will tell you it's all about speeds and feeds.</p><p></p><p>I use a Forster Original, I crank pretty fast but the goal is to make one long "chip". That will always be the smoothest most consistent cut.</p><p></p><p>Then keep turning very fast and back out slowly for a "finish" cut.</p></blockquote><p></p>
[QUOTE="Deleted member 46119, post: 992113"] A machinist will tell you it's all about speeds and feeds. I use a Forster Original, I crank pretty fast but the goal is to make one long "chip". That will always be the smoothest most consistent cut. Then keep turning very fast and back out slowly for a "finish" cut. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning.. fast vs slow, does it matter?
Top