Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning & annealing question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="KQguy" data-source="post: 267884" data-attributes="member: 9704"><p>I have been prepping alot of 7mmWSM brass lately.I use an expander mandrel on virgin brass prior to turning the necks.I think it is important to use an expander mandrel,that way it will force all the imperfections to the outside,so they can be sraped off with the neck turner.I only clean up about 80% of the neck,I try not to remove any more material than necessary.I turn down until the cutter just starts to scratch the shoulder,that way I know I cut far enough down.</p></blockquote><p></p>
[QUOTE="KQguy, post: 267884, member: 9704"] I have been prepping alot of 7mmWSM brass lately.I use an expander mandrel on virgin brass prior to turning the necks.I think it is important to use an expander mandrel,that way it will force all the imperfections to the outside,so they can be sraped off with the neck turner.I only clean up about 80% of the neck,I try not to remove any more material than necessary.I turn down until the cutter just starts to scratch the shoulder,that way I know I cut far enough down. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning & annealing question
Top