Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
Neck turner cutter question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="newmexkid" data-source="post: 869792" data-attributes="member: 33152"><p>The cutter on my neck turning setup seems to cut with about 1/3 of the cutter edge. Kinda like the cutter shaft is off-center. I have taken it apart, cleaned it and looked at it very closely. It does the job but, I feel it should cut with the entire edge of the cutter not just a portion of it. With the cutter on the neck of a piece of brass I can lift it up to a light and I can clearly see light between the cutter edge and the brass except at one small area. Is they normal?</p></blockquote><p></p>
[QUOTE="newmexkid, post: 869792, member: 33152"] The cutter on my neck turning setup seems to cut with about 1/3 of the cutter edge. Kinda like the cutter shaft is off-center. I have taken it apart, cleaned it and looked at it very closely. It does the job but, I feel it should cut with the entire edge of the cutter not just a portion of it. With the cutter on the neck of a piece of brass I can lift it up to a light and I can clearly see light between the cutter edge and the brass except at one small area. Is they normal? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
Neck turner cutter question
Top