Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Neck thickness and clearance?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="shortgrass" data-source="post: 1313790" data-attributes="member: 24284"><p>I would buy the brass I'm going to use, neck it down, seat a bullet and measure it. Then I'd take a new case or two, turn the necks after necking down, and seat a bullet to the desired length and send those examples to my tool maker for reference. .003" neck clearance is about right for a hunting rifle. Every 'run' of factory brass is not identical to the last 'run', or the next.</p></blockquote><p></p>
[QUOTE="shortgrass, post: 1313790, member: 24284"] I would buy the brass I'm going to use, neck it down, seat a bullet and measure it. Then I'd take a new case or two, turn the necks after necking down, and seat a bullet to the desired length and send those examples to my tool maker for reference. .003" neck clearance is about right for a hunting rifle. Every 'run' of factory brass is not identical to the last 'run', or the next. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Neck thickness and clearance?
Top