Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck Tension Effect on Accuracy
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Stoneke" data-source="post: 1254676" data-attributes="member: 97062"><p>Well, I did run a check on several loaded cases that had used each method of resizing. Out of six cases with the full length die, the run-out ran from .0007 to .002. With the bushing die, run-was was .0005 to over .004. I used a Hornady Concentricity gauge, which allows reading an estimated figure to the ten thousandth place and provides for a correction arm to reduce the final run-out. So, it seems as though the bushing die comes in at second place. All cases were same mfg and neck turned.</p></blockquote><p></p>
[QUOTE="Stoneke, post: 1254676, member: 97062"] Well, I did run a check on several loaded cases that had used each method of resizing. Out of six cases with the full length die, the run-out ran from .0007 to .002. With the bushing die, run-was was .0005 to over .004. I used a Hornady Concentricity gauge, which allows reading an estimated figure to the ten thousandth place and provides for a correction arm to reduce the final run-out. So, it seems as though the bushing die comes in at second place. All cases were same mfg and neck turned. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck Tension Effect on Accuracy
Top