Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck tension and max bullet grip force
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="longestrange" data-source="post: 2140047" data-attributes="member: 75265"><p>People tend to interpret stress/strain curves incorrectly. For annealed brass, you see the 'stress' go up at the modulus until the material yields, then gradually increase, then gradually decrease until failure. The actual stress, however, is increasing because the area decreases. If you unload a tensile bar before failure, it will come back up to the maximum previous load before yielding again. That would be called 'work hardening'.</p></blockquote><p></p>
[QUOTE="longestrange, post: 2140047, member: 75265"] People tend to interpret stress/strain curves incorrectly. For annealed brass, you see the 'stress' go up at the modulus until the material yields, then gradually increase, then gradually decrease until failure. The actual stress, however, is increasing because the area decreases. If you unload a tensile bar before failure, it will come back up to the maximum previous load before yielding again. That would be called 'work hardening'. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck tension and max bullet grip force
Top