Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck Sizing Vs. Full Length Sizing and Neck Tension
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mike Matteson" data-source="post: 2764830" data-attributes="member: 101791"><p>I was losing belted Mag case in about 3 or 4 firing. I change to only neck sizing the cases. That stop the case base separation. I used a 300WM neck sizing die for my 308NM. The neck on the 308NM is longer and to the shoulder is shorter. So it only sized 2/3 of the neck. If I had problem with the case not being allow to be chamber, then I would FL size them. I have been setting up to FL again but only bumping the should back a thousand or two.</p></blockquote><p></p>
[QUOTE="Mike Matteson, post: 2764830, member: 101791"] I was losing belted Mag case in about 3 or 4 firing. I change to only neck sizing the cases. That stop the case base separation. I used a 300WM neck sizing die for my 308NM. The neck on the 308NM is longer and to the shoulder is shorter. So it only sized 2/3 of the neck. If I had problem with the case not being allow to be chamber, then I would FL size them. I have been setting up to FL again but only bumping the should back a thousand or two. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck Sizing Vs. Full Length Sizing and Neck Tension
Top