Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck size tension?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="TG-5150" data-source="post: 1360427" data-attributes="member: 103379"><p>I have been using Lake City 7.62 brass for several years. Before the .308 became a 7mm-08 A.I. it was what i preferred to use. I would trim every 2-3 loadings, chamfer necks, clean primer pockets and brush neck. always have just wiped off the brass after resizing and when fully finished with a damp rag(vinegar). I think i may have trimmed sometimes before necessary. I have always liked loads on the higher ends of the chart. Until trolling this site and a few others for the last two years i didnt think weighing cases was critical.</p><p>one question i have is this: Is Lake City brass as easy to neck resize and fire form as the softer brasses are ? in my case it would be 7.62 necked to 7mm-08 to be fire formed to A.I.</p></blockquote><p></p>
[QUOTE="TG-5150, post: 1360427, member: 103379"] I have been using Lake City 7.62 brass for several years. Before the .308 became a 7mm-08 A.I. it was what i preferred to use. I would trim every 2-3 loadings, chamfer necks, clean primer pockets and brush neck. always have just wiped off the brass after resizing and when fully finished with a damp rag(vinegar). I think i may have trimmed sometimes before necessary. I have always liked loads on the higher ends of the chart. Until trolling this site and a few others for the last two years i didnt think weighing cases was critical. one question i have is this: Is Lake City brass as easy to neck resize and fire form as the softer brasses are ? in my case it would be 7.62 necked to 7mm-08 to be fire formed to A.I. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck size tension?
Top