Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
neck sise and sholder bump
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Reloader222" data-source="post: 558145" data-attributes="member: 25295"><p>I have found that 2 out of 10 reloaded cases would not chamber well in my .222 Rem. They were all sized in the same dies set. Hower some cases were from my own gun and others from my dad's. The only reason that I can think of is that the sizing of those cases which was fired in my gun, was sized sufficiently, but those from my dad's gun had probably needed the shoulders to be bumped back a little more. The cases are all Sako. From now on I would take a case that is difficult to chamber and then bump the shoulder back sufficient until it chambers well and keep that setting for all the cases. I do use the tool that fit on the vernier to measure the cases on the shoulder and must say that without that it is impossible to do it correctly. With this tool you also prevent the over-doing of the shoulder bumping, because too much bumping of the shoulder could cause headspace problems and also cause inaccurate groupings.</p></blockquote><p></p>
[QUOTE="Reloader222, post: 558145, member: 25295"] I have found that 2 out of 10 reloaded cases would not chamber well in my .222 Rem. They were all sized in the same dies set. Hower some cases were from my own gun and others from my dad's. The only reason that I can think of is that the sizing of those cases which was fired in my gun, was sized sufficiently, but those from my dad's gun had probably needed the shoulders to be bumped back a little more. The cases are all Sako. From now on I would take a case that is difficult to chamber and then bump the shoulder back sufficient until it chambers well and keep that setting for all the cases. I do use the tool that fit on the vernier to measure the cases on the shoulder and must say that without that it is impossible to do it correctly. With this tool you also prevent the over-doing of the shoulder bumping, because too much bumping of the shoulder could cause headspace problems and also cause inaccurate groupings. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
neck sise and sholder bump
Top