Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck bushing question...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="AZShooter" data-source="post: 841396" data-attributes="member: 5219"><p>Are you going to use new unturned brass? Or once fired factory brass? You were not clear on this. It is quite simple: measure the OD of the case neck with a bullet seated. Then subtract .001" and .002" from this number and order those bushings.</p><p></p><p></p><p></p><p> I suppose you could order a third bushing that is .003" smaller than neck OD. Depends on how much of the bullet is in contact with neck, neck wall thickness and rifle's recoil.</p></blockquote><p></p>
[QUOTE="AZShooter, post: 841396, member: 5219"] Are you going to use new unturned brass? Or once fired factory brass? You were not clear on this. It is quite simple: measure the OD of the case neck with a bullet seated. Then subtract .001" and .002" from this number and order those bushings. I suppose you could order a third bushing that is .003" smaller than neck OD. Depends on how much of the bullet is in contact with neck, neck wall thickness and rifle's recoil. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck bushing question...
Top