Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
model 70 push feed extraction problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Bigds" data-source="post: 3086836" data-attributes="member: 129507"><p>My push feed Winchester has the same issue. I replace the extractor and Spring, It made no real difference. Then I measured the cases at the base inside. I noticed Winchester cases are much thicker. All the cases that fail to extract are Winchester. Remington cases extract much better. And they are thinner in diameter. Used a set of calipers to get these measurements. I mean 10 cases allow the extractor to get a better bite. When the shell leaves the barrel it Kix to the side a little bit more. Which allows the ejector to knock it out of the extractor. The only fixed IC is to buy a rifle with a better extractor. A rifle is no good if you can't get the shell out of the chamber Is controlled feed is the only way to go.</p></blockquote><p></p>
[QUOTE="Bigds, post: 3086836, member: 129507"] My push feed Winchester has the same issue. I replace the extractor and Spring, It made no real difference. Then I measured the cases at the base inside. I noticed Winchester cases are much thicker. All the cases that fail to extract are Winchester. Remington cases extract much better. And they are thinner in diameter. Used a set of calipers to get these measurements. I mean 10 cases allow the extractor to get a better bite. When the shell leaves the barrel it Kix to the side a little bit more. Which allows the ejector to knock it out of the extractor. The only fixed IC is to buy a rifle with a better extractor. A rifle is no good if you can't get the shell out of the chamber Is controlled feed is the only way to go. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
model 70 push feed extraction problem
Top