Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Long Range Scopes and Other Optics
Mechanics vs non
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Darryle" data-source="post: 3073370" data-attributes="member: 109917"><p>I start with a set of feeler gauges under the edges of each cap once I have established the correct spacing, usually between .029" and .032" depending on the brand. Then I use the same method as most, criss/cross like lug nuts to slowly get them to the recommended torque. It helps me keep the gap correct once I start. It's an OCD thing for me more than a guarantee thing.</p><p></p><p>Started because a coworker was struggling with a rifle and it's lack of consistency. Took him to the range and one session behind the rifle drove me crazy looking at a huge gap on one side and none on the other along with the canted reticle. Turns out one loose base and poor mounting skills, actually complete lack of skills were his issue. Removed everything, cleaned it up, remounted and properly torqued and the rifle went from fliers making groups grow up to about 4" at 100yds with no repeatable pattern, just all over the target to 3 shot groups right at an 1" at 100yds.</p><p></p><p></p><p>Two sets of these and you are in business, takes seconds and the narrow tip usually fits between the 2 screws and stays in place until you get your gap established, level the reticle and then they easily pull out. First time is a little awkward, but you soon get a method and rhythm going. A little Plano slotted box keeps them organized.</p><p>[ATTACH=full]559108[/ATTACH]</p></blockquote><p></p>
[QUOTE="Darryle, post: 3073370, member: 109917"] I start with a set of feeler gauges under the edges of each cap once I have established the correct spacing, usually between .029" and .032" depending on the brand. Then I use the same method as most, criss/cross like lug nuts to slowly get them to the recommended torque. It helps me keep the gap correct once I start. It's an OCD thing for me more than a guarantee thing. Started because a coworker was struggling with a rifle and it's lack of consistency. Took him to the range and one session behind the rifle drove me crazy looking at a huge gap on one side and none on the other along with the canted reticle. Turns out one loose base and poor mounting skills, actually complete lack of skills were his issue. Removed everything, cleaned it up, remounted and properly torqued and the rifle went from fliers making groups grow up to about 4" at 100yds with no repeatable pattern, just all over the target to 3 shot groups right at an 1" at 100yds. Two sets of these and you are in business, takes seconds and the narrow tip usually fits between the 2 screws and stays in place until you get your gap established, level the reticle and then they easily pull out. First time is a little awkward, but you soon get a method and rhythm going. A little Plano slotted box keeps them organized. [ATTACH type="full"]559108[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Long Range Scopes and Other Optics
Mechanics vs non
Top