Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Mauser feed rails
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="CaptnC" data-source="post: 1351944" data-attributes="member: 101755"><p>The 300wm has CDI BM. I had to do a couple mods to it...</p><p></p><p>First I had to cut a notch in the feed ramp for bullet clearance (a problem you will not have) and I trimmed the bullet end of the follower of the mag so it would clear the feed ramp..</p><p></p><p>I will see how good of pictures I can get. The 300wm has a EGW Scope rail on it so that area is pretty tight. The 308 has better clearance to see.</p><p></p><p>Sorry I can't help you on what where and how much to trim...I just find away around doing that.</p><p></p><p>OMT- the extractor will cause more feed problems than rail. I've been constructive swapping them as well. But if the case hangs up just before it chambers it the extractor causing that.</p></blockquote><p></p>
[QUOTE="CaptnC, post: 1351944, member: 101755"] The 300wm has CDI BM. I had to do a couple mods to it... First I had to cut a notch in the feed ramp for bullet clearance (a problem you will not have) and I trimmed the bullet end of the follower of the mag so it would clear the feed ramp.. I will see how good of pictures I can get. The 300wm has a EGW Scope rail on it so that area is pretty tight. The 308 has better clearance to see. Sorry I can't help you on what where and how much to trim...I just find away around doing that. OMT- the extractor will cause more feed problems than rail. I've been constructive swapping them as well. But if the case hangs up just before it chambers it the extractor causing that. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Mauser feed rails
Top