Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Making brass for 6mm Rem AI
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="zoeper" data-source="post: 386201" data-attributes="member: 10682"><p>I want to make some brass for a 6mm Rem AI project.</p><p>I can get hold of the following good brass and would like to hear your opinions as to what the best parent case would be. (keep in mind that 7x57 Norma brass is not available)</p><p></p><p>Lapua: </p><p>30-06 (would have to be cut down first)</p><p>6.5x55 (would end up a bit short)</p><p></p><p>Norma:</p><p>9.3x57</p><p>6.5x55</p><p>8x57JS</p><p></p><p>Any advice much apreciated.</p><p>P</p></blockquote><p></p>
[QUOTE="zoeper, post: 386201, member: 10682"] I want to make some brass for a 6mm Rem AI project. I can get hold of the following good brass and would like to hear your opinions as to what the best parent case would be. (keep in mind that 7x57 Norma brass is not available) Lapua: 30-06 (would have to be cut down first) 6.5x55 (would end up a bit short) Norma: 9.3x57 6.5x55 8x57JS Any advice much apreciated. P [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Making brass for 6mm Rem AI
Top