Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Mag box problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="GunDoc7" data-source="post: 908047" data-attributes="member: 71324"><p>Last winter I finished building a custom 700 that originated as a .243 BDL model and during the build I chambered the new barrel for the 6.5-.284 Norma; everything came together fantastically and for the first few months of shooting I had replaced the factory shell follower with an aftermarket one for single shot lolading at the range and all was fine. However, when deer season came up and I tried to load the secondary rounds into the magazine box I found my new round's OAL is too long to fit. So to make this as short as possible I know I have a couple obvious options, and I have a few fabrications in mind as well if it comes to that, I'm just wondering if anyone has come across this and what direction they went.</p></blockquote><p></p>
[QUOTE="GunDoc7, post: 908047, member: 71324"] Last winter I finished building a custom 700 that originated as a .243 BDL model and during the build I chambered the new barrel for the 6.5-.284 Norma; everything came together fantastically and for the first few months of shooting I had replaced the factory shell follower with an aftermarket one for single shot lolading at the range and all was fine. However, when deer season came up and I tried to load the secondary rounds into the magazine box I found my new round's OAL is too long to fit. So to make this as short as possible I know I have a couple obvious options, and I have a few fabrications in mind as well if it comes to that, I'm just wondering if anyone has come across this and what direction they went. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Mag box problem
Top