Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Load Development for .357 Revolver
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Huckleberry75" data-source="post: 2629659" data-attributes="member: 104886"><p>Adjust the die up and lower the seating stem to get the bullet seated to where you want it. Once the bullet is seated to your desired depth, run the seat stem up out of the way and start working the die down to set your crimp. Once you have the desired amount of crimp set, run your seating stem back down to firmly contact the top of the bullet when the ram is topped out and lock it down. Then you will seat and crimp in one motion. You shouldn't have to adjust the die up and down between seating and crimping. Those rcbs dies will do you just fine. </p><p></p><p>Does this make sense?</p></blockquote><p></p>
[QUOTE="Huckleberry75, post: 2629659, member: 104886"] Adjust the die up and lower the seating stem to get the bullet seated to where you want it. Once the bullet is seated to your desired depth, run the seat stem up out of the way and start working the die down to set your crimp. Once you have the desired amount of crimp set, run your seating stem back down to firmly contact the top of the bullet when the ram is topped out and lock it down. Then you will seat and crimp in one motion. You shouldn't have to adjust the die up and down between seating and crimping. Those rcbs dies will do you just fine. Does this make sense? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Load Development for .357 Revolver
Top