Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Lengthening factory throats?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jimbires" data-source="post: 1587099" data-attributes="member: 11011"><p>just a couple of things I've thought of to mention to you . </p><p> be sure the bullet loaded to the case shoulder junction will fit your magazine . I think it was already mentioned , these reamers cut fast , be careful . watch the two brass depth control nuts on the reamer , to be sure they don't come loose while turning the reamer . the nuts came loose for me at the beginning of the cutting , it really didn't matter at that point , if they would have came loose close to the end it could have been bad . </p><p> take your time , pay close attention , you'll be fine .</p></blockquote><p></p>
[QUOTE="jimbires, post: 1587099, member: 11011"] just a couple of things I've thought of to mention to you . be sure the bullet loaded to the case shoulder junction will fit your magazine . I think it was already mentioned , these reamers cut fast , be careful . watch the two brass depth control nuts on the reamer , to be sure they don't come loose while turning the reamer . the nuts came loose for me at the beginning of the cutting , it really didn't matter at that point , if they would have came loose close to the end it could have been bad . take your time , pay close attention , you'll be fine . [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Lengthening factory throats?
Top