Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Larry Willis Belted magnum case-bulge dies
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Dr. Vette" data-source="post: 946582" data-attributes="member: 22335"><p>If only this was the always the case. </p><p> </p><p>In the 100 or so cases I finally got to work without breaking anything it did seem to slowly get a tiny bit easier over time. That is, until I broke the press because it all required so much effort. As I mentioned above I suspect that my die - and the original poster's die - have enough tolerance variation that ours stick a lot more than intended. I have tried less Imperial, more, variations on the theme, and every suggestion from Larry and elsewhere. If I had a good way to measure it as well as a lathe I'd be tempted to have the inside opened up just a nominal amount to see if that helped at all.</p></blockquote><p></p>
[QUOTE="Dr. Vette, post: 946582, member: 22335"] If only this was the always the case. In the 100 or so cases I finally got to work without breaking anything it did seem to slowly get a tiny bit easier over time. That is, until I broke the press because it all required so much effort. As I mentioned above I suspect that my die - and the original poster's die - have enough tolerance variation that ours stick a lot more than intended. I have tried less Imperial, more, variations on the theme, and every suggestion from Larry and elsewhere. If I had a good way to measure it as well as a lathe I'd be tempted to have the inside opened up just a nominal amount to see if that helped at all. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Larry Willis Belted magnum case-bulge dies
Top