Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Keyholing bullets in 338 lapua/weatherbyorked
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Quicksilver338" data-source="post: 1598642" data-attributes="member: 108268"><p>Some comments may seem too obvious, but make a long list of anything you can think of and comments on here. I thought my 338 barrel was done at 750rds but had carbon fouling caked on that took special attention to remove. Afterwards it's shooting sub half inch and is back to before. Things happen over time and it's best to be methodical about it and there is no stupid question asked!</p></blockquote><p></p>
[QUOTE="Quicksilver338, post: 1598642, member: 108268"] Some comments may seem too obvious, but make a long list of anything you can think of and comments on here. I thought my 338 barrel was done at 750rds but had carbon fouling caked on that took special attention to remove. Afterwards it’s shooting sub half inch and is back to before. Things happen over time and it’s best to be methodical about it and there is no stupid question asked! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Keyholing bullets in 338 lapua/weatherbyorked
Top