Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Internal ballistics frustration.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Michael Eichele" data-source="post: 132768" data-attributes="member: 1007"><p>I just got back from the range. I shot 5 rounds with twice fired cases and one 3 times fired case that was a bad offender. After resizing them to just bump the shoulder .001"-.002" instead of .005" helped quite a bit. They all had slightly difficult bolt lift, but not too bad. Slightly difficult meaning that, I can feel some resistance while lifting the bolt, then to get it to pop all the way up, it takes some minor to minorly moderate force. The actual extraction (act of pulling the bolt back and case out) was easy. Just the bolt lift required a little persuasion.</p><p></p><p>None of them pulled my extractor apart this time. Next I am going to try .0005-.001" and see if that improves it any more.</p></blockquote><p></p>
[QUOTE="Michael Eichele, post: 132768, member: 1007"] I just got back from the range. I shot 5 rounds with twice fired cases and one 3 times fired case that was a bad offender. After resizing them to just bump the shoulder .001"-.002" instead of .005" helped quite a bit. They all had slightly difficult bolt lift, but not too bad. Slightly difficult meaning that, I can feel some resistance while lifting the bolt, then to get it to pop all the way up, it takes some minor to minorly moderate force. The actual extraction (act of pulling the bolt back and case out) was easy. Just the bolt lift required a little persuasion. None of them pulled my extractor apart this time. Next I am going to try .0005-.001" and see if that improves it any more. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Internal ballistics frustration.
Top