Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Induction annealing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Tac-O" data-source="post: 2286604" data-attributes="member: 109994"><p>Temperature controller? To monitor temperature of the case neck while annealing?</p><p></p><p>I think that would be near impossible with a sensor. I was thinking about how AMP might have created their "smart" technology into their machine and at first thought a thermal imaging camera might have been used, but there'd be no way to get a good view of case neck and shoulder. Any sensor placed close enough to the case and therefore coil to get a measurement would be fried by the induced currents on it. </p><p></p><p>I think what they did was measure the power consumption vs time for various case sizes for a "perfect" anneal and put that into a software that gives the correct time after destroying the test case. That's basically what a diy builder would do, but manually. Find what voltage setting and time gives you the result you want for a particular case type and brand and record it for future use.</p></blockquote><p></p>
[QUOTE="Tac-O, post: 2286604, member: 109994"] Temperature controller? To monitor temperature of the case neck while annealing? I think that would be near impossible with a sensor. I was thinking about how AMP might have created their "smart" technology into their machine and at first thought a thermal imaging camera might have been used, but there'd be no way to get a good view of case neck and shoulder. Any sensor placed close enough to the case and therefore coil to get a measurement would be fried by the induced currents on it. I think what they did was measure the power consumption vs time for various case sizes for a "perfect" anneal and put that into a software that gives the correct time after destroying the test case. That's basically what a diy builder would do, but manually. Find what voltage setting and time gives you the result you want for a particular case type and brand and record it for future use. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Induction annealing
Top