Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
I'm stumped!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="arthurj" data-source="post: 67447" data-attributes="member: 3718"><p><strong>I\'m stumped!</strong></p><p></p><p>Hey guys, I posted a week ago about my sizing die. I wasn't getting enough shoulder bump from my redding body die. The caliber is 308. I must be doing something wrong, I have the wilson drop in headspace gauge. I put the bottom of the caliper on the neck end of the gauge and the other end of the caliper on the head of the shell. My measurement after two firings is 2.008. When I run the shell as far into the die as it will go, I get the same headspace measurement afterwards and when I try to chamber the shell the bolt is very hard to close. I thought of having some of the die shaved off but instead I replaced it, getting the same result. Could my chamber be short, or what am I doing wrong? It's just a factory rem vsf Thanks in advance</p></blockquote><p></p>
[QUOTE="arthurj, post: 67447, member: 3718"] [b]I\'m stumped![/b] Hey guys, I posted a week ago about my sizing die. I wasn't getting enough shoulder bump from my redding body die. The caliber is 308. I must be doing something wrong, I have the wilson drop in headspace gauge. I put the bottom of the caliper on the neck end of the gauge and the other end of the caliper on the head of the shell. My measurement after two firings is 2.008. When I run the shell as far into the die as it will go, I get the same headspace measurement afterwards and when I try to chamber the shell the bolt is very hard to close. I thought of having some of the die shaved off but instead I replaced it, getting the same result. Could my chamber be short, or what am I doing wrong? It's just a factory rem vsf Thanks in advance [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
I'm stumped!
Top