Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Hydraulic Case form Die
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="FEENIX" data-source="post: 2763616" data-attributes="member: 14204"><p>Here's the hydraulic forming die that my GS built me per #4. You will also need a modified(plugged shellholder, see picture.</p><p></p><p>[ATTACH=full]444146[/ATTACH]</p><p></p><p>Below is my first attempt from a few minutes ago.</p><p></p><p>[ATTACH=full]444147[/ATTACH]</p><p>L-R</p><p>- Virgin Lapua .338 NM brass</p><p>- After running through the hydraulic forming die: it needs adjustment so the neck is not too far forward.</p><p>- After running through the sizing die.</p><p></p><p>Contrary to what you have heard about insufficient force pressure to form using a hydraulic forming die, some of us have had very good success with it.</p><p></p><p>Below is my .30 LARA</p><p></p><p>[ATTACH=full]444150[/ATTACH]</p><p></p><p>L-R</p><p></p><p>- Virgin 8MM RM brass.</p><p>- After running through hydraulic forming die (Whidden).</p><p>- After running through the sizing die.</p><p>- Fire formed off the chamber with a full load.</p><p></p><p>Good luck!</p></blockquote><p></p>
[QUOTE="FEENIX, post: 2763616, member: 14204"] Here's the hydraulic forming die that my GS built me per #4. You will also need a modified(plugged shellholder, see picture. [ATTACH type="full"]444146[/ATTACH] Below is my first attempt from a few minutes ago. [ATTACH type="full"]444147[/ATTACH] L-R - Virgin Lapua .338 NM brass - After running through the hydraulic forming die: it needs adjustment so the neck is not too far forward. - After running through the sizing die. Contrary to what you have heard about insufficient force pressure to form using a hydraulic forming die, some of us have had very good success with it. Below is my .30 LARA [ATTACH type="full"]444150[/ATTACH] L-R - Virgin 8MM RM brass. - After running through hydraulic forming die (Whidden). - After running through the sizing die. - Fire formed off the chamber with a full load. Good luck! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Hydraulic Case form Die
Top