Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Long Range Hunting & Shooting
Huge poi shift and bore sight oddity
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Grizz1148" data-source="post: 1816468" data-attributes="member: 84418"><p>So I'll try to explain as short as possible, buddy just bought a Christensen Mesa 338. He shot a few groups not so hot but breaking in the rifle as Christensen states. I go there today and he says shoot it, so I did. Peterson brass, rel 33, Berger 300 otm, misses 100 yd target completely to the right twice. Dial it over and can't tell where it's going. Loaded some more, here's where it gets weird. Bore sighted as I do with every gun every time with no issues. Look through bore and align bullseye with scope. Usually always within a few inches of center and never off paper, until now, at 50 yds. Over 12 inches left. Now to center it we had to max out windage in the scope and found that the 40 min NF rail was too much for the scope and didn't allow for enough horizontal travel. Tried another scope to be sure it wasn't just the scope. Replaced with 20 min rail and was able to move over enough to sight in. Same thing bore sight looked good, shot way left. We then sighted in at 100 and shot 3 shot group, not great but consistent. Decided to load a few Barnes lrxs 265, same powder, case, primer, brass, poi shifts over 10 inches right at 100 yds. Dumbfounded by this we fired another Berger to be sure scope didn't shift and it had not, that bulletin fired back in the group of bergers. Any ideas?</p></blockquote><p></p>
[QUOTE="Grizz1148, post: 1816468, member: 84418"] So I’ll try to explain as short as possible, buddy just bought a Christensen Mesa 338. He shot a few groups not so hot but breaking in the rifle as Christensen states. I go there today and he says shoot it, so I did. Peterson brass, rel 33, Berger 300 otm, misses 100 yd target completely to the right twice. Dial it over and can’t tell where it’s going. Loaded some more, here’s where it gets weird. Bore sighted as I do with every gun every time with no issues. Look through bore and align bullseye with scope. Usually always within a few inches of center and never off paper, until now, at 50 yds. Over 12 inches left. Now to center it we had to max out windage in the scope and found that the 40 min NF rail was too much for the scope and didn’t allow for enough horizontal travel. Tried another scope to be sure it wasn’t just the scope. Replaced with 20 min rail and was able to move over enough to sight in. Same thing bore sight looked good, shot way left. We then sighted in at 100 and shot 3 shot group, not great but consistent. Decided to load a few Barnes lrxs 265, same powder, case, primer, brass, poi shifts over 10 inches right at 100 yds. Dumbfounded by this we fired another Berger to be sure scope didn’t shift and it had not, that bulletin fired back in the group of bergers. Any ideas? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Long Range Hunting & Shooting
Huge poi shift and bore sight oddity
Top