Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
How to select a bullet?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="snox801" data-source="post: 1889802" data-attributes="member: 54383"><p>Fact is I've never measured it off the lands. </p><p> I loaded just short of my mag length. Magpul mag and did a ladder. When they all shot that good I didn't try to mess with it. Mainly because most were around the .3 moa so even at .5 moa which was the worst. I would run out of speed before that caused me to miss a animal. 600 yards roughly 3". I haven't had a ton of time to play with it with my other projects going on. But when I'm in my new house I will be going higher with my charge and playing with seating a bit. Mainly to see if I can get to or over 3000 FPS and keep good groups and safe pressure. Sitting at just over 2900 now With no .</p><p>pressure. Hammers do not seem to care very much about seating depth.</p><p> In fact my new way to load them is to do one round of each charge weight till I find pressure. Then back off 1 gr and do a 5 shot group. If it shoots good which they have then I see where the velocity spread is at. If single digits I leave if not I'll go either side of that charge and see.</p></blockquote><p></p>
[QUOTE="snox801, post: 1889802, member: 54383"] Fact is I’ve never measured it off the lands. I loaded just short of my mag length. Magpul mag and did a ladder. When they all shot that good I didn’t try to mess with it. Mainly because most were around the .3 moa so even at .5 moa which was the worst. I would run out of speed before that caused me to miss a animal. 600 yards roughly 3”. I haven’t had a ton of time to play with it with my other projects going on. But when I’m in my new house I will be going higher with my charge and playing with seating a bit. Mainly to see if I can get to or over 3000 FPS and keep good groups and safe pressure. Sitting at just over 2900 now With no . pressure. Hammers do not seem to care very much about seating depth. In fact my new way to load them is to do one round of each charge weight till I find pressure. Then back off 1 gr and do a 5 shot group. If it shoots good which they have then I see where the velocity spread is at. If single digits I leave if not I’ll go either side of that charge and see. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
How to select a bullet?
Top