Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
how to bed this?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="royinidaho" data-source="post: 167081" data-attributes="member: 2011"><p>If it were mine and I were in your situation I'd go to the local farm/hardware store and get one (1) 1/4" electric fence post. They are about 4" long. Usually they are white and made of some kind of epoxy material. When full length they are flexible. Cut to 3 or 4" they are stiff. My last one cost me a dollar buck 50.</p><p></p><p>I'd dig out ,by whatever means are at hand a, slot that goes from the front of the void ahead of the recoil lug up the fore end for a couple or 3". That could give you as much as 5" of rod or so to cut.</p><p></p><p>Get some kind of epoxy, devcon, jb weld or whatever that will stick to both pieces of material. (I'm not sure that any of the ones i mentioned will?) Dab a little along the bottom of the void and the dug channel.</p><p></p><p>Press in the rod and cover w/whatever it is you choose.</p><p></p><p>If the flex point is where is is from my hollow stocks that should stiffen it quite a bit.</p></blockquote><p></p>
[QUOTE="royinidaho, post: 167081, member: 2011"] If it were mine and I were in your situation I'd go to the local farm/hardware store and get one (1) 1/4" electric fence post. They are about 4" long. Usually they are white and made of some kind of epoxy material. When full length they are flexible. Cut to 3 or 4" they are stiff. My last one cost me a dollar buck 50. I'd dig out ,by whatever means are at hand a, slot that goes from the front of the void ahead of the recoil lug up the fore end for a couple or 3". That could give you as much as 5" of rod or so to cut. Get some kind of epoxy, devcon, jb weld or whatever that will stick to both pieces of material. (I'm not sure that any of the ones i mentioned will?) Dab a little along the bottom of the void and the dug channel. Press in the rod and cover w/whatever it is you choose. If the flex point is where is is from my hollow stocks that should stiffen it quite a bit. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
how to bed this?
Top