Hornady match bushing size 6.5 PRC

[105Coues]

Using hornady brass and a .291 bushing with Hornady Match dies and almost zero neck tension on my 6.5 PRC. What bushing are you guys using for this combo?

 

[GLTaylor]

You need to measure your brass neck thickness with a ball mike. 014 is common. Yours must be .013 or less.
Cal dia (.264) + 2xs neck thickness⁰ = loaded cartridge dia. Most prefer about .002 tension.
264+28=292, minus .002 means you need a .290 bushing (or less).

 

[can1010]

measure a loaded round and then subtract .002-.003. I used a .289 when I had mine. remove the expander and replace with the decapping pin retainer my expander was to large and opened the neck to much

 

[105Coues]

Thanks. When I started I couldn't find a loaded round so I used the first method. The brass is not uniform so I averaged. Think I will try that .289