Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
Hornady custom grade new dimension dies
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="winmagman" data-source="post: 45370" data-attributes="member: 1193"><p>Is any one using these dies praticularly in 6.5-284.</p><p>I just got back from breaking in a new barrel, while there I had 2 rounds the would not chamber. The bullet itself seemed to be hitting something about 1/4 inch above the neck. The mark wasn't from the lands as it was one solid line about a quarter of the way around the bullet.</p><p>Well needles to say when I got home I measured every concievable place I could think of. Every thing matched the other rounds I'd loaded that chambered just fine. I was just about to start pulling my hair out when I knocked one of the problem rounds over and as it rolled across the bench I could see the bullet was out of round in the case, and not just by a little bit . So what I'm wondering is if any one else is having trouble getting concetric (sp) rounds with these dies or did I just get a bad set?</p><p>Thanks in advance</p><p>Chris</p></blockquote><p></p>
[QUOTE="winmagman, post: 45370, member: 1193"] Is any one using these dies praticularly in 6.5-284. I just got back from breaking in a new barrel, while there I had 2 rounds the would not chamber. The bullet itself seemed to be hitting something about 1/4 inch above the neck. The mark wasn't from the lands as it was one solid line about a quarter of the way around the bullet. Well needles to say when I got home I measured every concievable place I could think of. Every thing matched the other rounds I'd loaded that chambered just fine. I was just about to start pulling my hair out when I knocked one of the problem rounds over and as it rolled across the bench I could see the bullet was out of round in the case, and not just by a little bit . So what I'm wondering is if any one else is having trouble getting concetric (sp) rounds with these dies or did I just get a bad set? Thanks in advance Chris [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
Hornady custom grade new dimension dies
Top