Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Hitting pressure early in 6.5 PRC
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Hard rock" data-source="post: 2224394" data-attributes="member: 116620"><p>I show early signs of pressure with nosler brass with my 6.5 284 norma but not with my 2 6.5 prcs using hornady brass I've worked up too 63.5 grs of n165 with a cci 250 mag primer toped with a 123 gr absolute hammer at 3452 fps with no pressure issues the 6.5 prc has been one of the easist cartridges I've loaded for but I'm not at saami specs . 145 freebore unless your loosing primer pockets ejector marks etc bolt lift could be a sizing issue allways be careful all else fails have a competent gunsmith check your chambering</p></blockquote><p></p>
[QUOTE="Hard rock, post: 2224394, member: 116620"] I show early signs of pressure with nosler brass with my 6.5 284 norma but not with my 2 6.5 prcs using hornady brass I've worked up too 63.5 grs of n165 with a cci 250 mag primer toped with a 123 gr absolute hammer at 3452 fps with no pressure issues the 6.5 prc has been one of the easist cartridges I've loaded for but I'm not at saami specs . 145 freebore unless your loosing primer pockets ejector marks etc bolt lift could be a sizing issue allways be careful all else fails have a competent gunsmith check your chambering [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Hitting pressure early in 6.5 PRC
Top