Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Headspacing for 7mm stw?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tackdriver10" data-source="post: 385008" data-attributes="member: 21430"><p>You would want to go one full turn, so that the engraving ends up in the same place. It will make things so much simpler when you set the headspace. I'm not sure what thread pitch on the weatherbys are because I have yet to do one myself. However if it is 16 TPI, (just like the remmys) then that is only .0625 of material that you would remove from the end of the barrel. Not very much at all. I don't think you will notice any difference in cosmetics or in velocity.</p></blockquote><p></p>
[QUOTE="tackdriver10, post: 385008, member: 21430"] You would want to go one full turn, so that the engraving ends up in the same place. It will make things so much simpler when you set the headspace. I'm not sure what thread pitch on the weatherbys are because I have yet to do one myself. However if it is 16 TPI, (just like the remmys) then that is only .0625 of material that you would remove from the end of the barrel. Not very much at all. I don't think you will notice any difference in cosmetics or in velocity. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Headspacing for 7mm stw?
Top