Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Getting sharp lines when bedding the action?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jimbires" data-source="post: 2000616" data-attributes="member: 11011"><p>I did one over again , that the bedding was failing . it had a loose pillar , the bedding was cracking and falling out . the original bedding job let the compound just run forward too . I ground out all the old bedding with a dremel . reset the pillar , and bedded it with 10110 devcon . I used Ernie the gun smith accu risers , so I had firm contact with the pillars . this is an aluminum block stock .</p></blockquote><p></p>
[QUOTE="jimbires, post: 2000616, member: 11011"] I did one over again , that the bedding was failing . it had a loose pillar , the bedding was cracking and falling out . the original bedding job let the compound just run forward too . I ground out all the old bedding with a dremel . reset the pillar , and bedded it with 10110 devcon . I used Ernie the gun smith accu risers , so I had firm contact with the pillars . this is an aluminum block stock . [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Getting sharp lines when bedding the action?
Top