Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Full Length or Neck Only; What's Best Resizing for Accuracy?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DJ Fergus" data-source="post: 1846193" data-attributes="member: 93895"><p>This is my thoughts also, in far to many situations the run of the mill and even alot of more expensive full length dies size the case way down farther than needed for most average chambers. If a fellow is going to have a custom FL die reamed to match his chamber for minimal case sizing, it would be hard to do another method that would be any better than that. Its difficult for me to say that a fellow could go buy a $39 or even possibly up to $200 mass produced die set and always, in every situation, & with any rifle have better results full length sizing than he would neck sizing in every single situation. There's a ton of variables there. If a fellow has the funds for a custom made FL die reamed for his chamber and if that cost is practical for his intended application, then that is what he should go with.</p></blockquote><p></p>
[QUOTE="DJ Fergus, post: 1846193, member: 93895"] This is my thoughts also, in far to many situations the run of the mill and even alot of more expensive full length dies size the case way down farther than needed for most average chambers. If a fellow is going to have a custom FL die reamed to match his chamber for minimal case sizing, it would be hard to do another method that would be any better than that. Its difficult for me to say that a fellow could go buy a $39 or even possibly up to $200 mass produced die set and always, in every situation, & with any rifle have better results full length sizing than he would neck sizing in every single situation. There's a ton of variables there. If a fellow has the funds for a custom made FL die reamed for his chamber and if that cost is practical for his intended application, then that is what he should go with. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Full Length or Neck Only; What's Best Resizing for Accuracy?
Top