Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Full Length or Neck Only; What's Best Resizing for Accuracy?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="J E Custom" data-source="post: 1818735" data-attributes="member: 2736"><p>I turn all of the necks on my cases, some are new and others are once fired. I have some friends that don't re load</p><p>and they save me their brass because it goes with my reamers and chambers. when It is fired without first turning,</p><p>It will take two firings before it is perfectly concentric inside the neck and on the OD of the case. </p><p></p><p>If I turn the case when new, it only takes one firing to do the same, and I can start load development sooner and work the brass less.</p><p></p><p>So the answer is yes you can turn after the first firing, but it saves the case from being reformed by the chamber because once it has been fired with the neck thickness difference, it will adhere/form to the chamber and move the neck bore off center by the amount of the difference, and then have to move it again.</p><p></p><p>It is just the best way I have found to true my cases If I can do it on the first firing.</p><p></p><p>Jerry</p></blockquote><p></p>
[QUOTE="J E Custom, post: 1818735, member: 2736"] I turn all of the necks on my cases, some are new and others are once fired. I have some friends that don't re load and they save me their brass because it goes with my reamers and chambers. when It is fired without first turning, It will take two firings before it is perfectly concentric inside the neck and on the OD of the case. If I turn the case when new, it only takes one firing to do the same, and I can start load development sooner and work the brass less. So the answer is yes you can turn after the first firing, but it saves the case from being reformed by the chamber because once it has been fired with the neck thickness difference, it will adhere/form to the chamber and move the neck bore off center by the amount of the difference, and then have to move it again. It is just the best way I have found to true my cases If I can do it on the first firing. Jerry [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Full Length or Neck Only; What's Best Resizing for Accuracy?
Top