Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Flatning Primers and Blowing Out Primers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="J E Custom" data-source="post: 453426" data-attributes="member: 2736"><p>If you are getting pressure at the starting loads there are several reasons.</p><p></p><p>Look at the fired brass and insert a new bullet in the case, (It should fall in). If it doesent go in </p><p>easy then you have a tight neck or it is longer than the neck portion of the chamber.</p><p></p><p>If it is not to long (Can be fixed by trimming) then you may/must turn the necks down.</p><p></p><p>The other thing it could be is bullet seating depth . If it is touching the lands at all it will raise</p><p>the pressure and it will need to be seated .020 off the lands and then you can work closer to</p><p>the lands in steps of .005.</p><p></p><p>Some chambers have no free bore and this is a common condition if not dealt with.</p><p></p><p>There is nothing wrong with the primers as long as it is the one listed in the load data.</p><p></p><p>I hope this helped.</p><p></p><p>J E CUSTOM</p></blockquote><p></p>
[QUOTE="J E Custom, post: 453426, member: 2736"] If you are getting pressure at the starting loads there are several reasons. Look at the fired brass and insert a new bullet in the case, (It should fall in). If it doesent go in easy then you have a tight neck or it is longer than the neck portion of the chamber. If it is not to long (Can be fixed by trimming) then you may/must turn the necks down. The other thing it could be is bullet seating depth . If it is touching the lands at all it will raise the pressure and it will need to be seated .020 off the lands and then you can work closer to the lands in steps of .005. Some chambers have no free bore and this is a common condition if not dealt with. There is nothing wrong with the primers as long as it is the one listed in the load data. I hope this helped. J E CUSTOM [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Flatning Primers and Blowing Out Primers
Top