Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
Flatline Ops. Inc. ACCU/LEVEL Scope Level Review
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="milanuk" data-source="post: 461247" data-attributes="member: 376"><p>Got mine in last week; haven't got it to the range yet. </p><p></p><p>I stuck it on my 110BA .338LM w/ NF NXS 5.5-22x50, and I have to say... that was bout the least painful mounting of a level I've ever experienced. Usually it goes something like (for me, at least): level the gun, clamp it, level the scope (using machinist levels here), snug it down. Mount the scope level, snug it a bit, twist it back to center, tighten one screw, then another, then somewhere along the way it gets off to one side, loosen up, start over, do it again, cuss, start over, happens again, cuss some more... eventually get it right. This was level the gun, clamp it, level the scope, snug it down, mount the level, get it close, snug it down, fine tune with the set screws, done. Hallelujah!!!!</p><p></p><p>Hopefully it works as good as it looks. I've got an ACI sitting here unused, I might just have to order that accessory-mount-thingy to stick it on there...</p></blockquote><p></p>
[QUOTE="milanuk, post: 461247, member: 376"] Got mine in last week; haven't got it to the range yet. I stuck it on my 110BA .338LM w/ NF NXS 5.5-22x50, and I have to say... that was bout the least painful mounting of a level I've ever experienced. Usually it goes something like (for me, at least): level the gun, clamp it, level the scope (using machinist levels here), snug it down. Mount the scope level, snug it a bit, twist it back to center, tighten one screw, then another, then somewhere along the way it gets off to one side, loosen up, start over, do it again, cuss, start over, happens again, cuss some more... eventually get it right. This was level the gun, clamp it, level the scope, snug it down, mount the level, get it close, snug it down, fine tune with the set screws, done. Hallelujah!!!! Hopefully it works as good as it looks. I've got an ACI sitting here unused, I might just have to order that accessory-mount-thingy to stick it on there... [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
Flatline Ops. Inc. ACCU/LEVEL Scope Level Review
Top