Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
FL shoulder bump question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="trout004" data-source="post: 2748324" data-attributes="member: 119527"><p>Here are some things that I have done to when I was struggling with the same problems with shoulder runout:</p><p></p><p>1. Like mentioned above, make sure lubrication is applied in a consistent manner. </p><p>2. I have found that inconsistencies or slop in the shell holder can cause this. I have made it a practice to make sure the shell holder is in the same position every time. I run a couple of wraps of electricians tape around them to keep them, securing it to the press ram, clocked in a single position for the entire time that I reload that particular lot (this may or may not work for you depending on the type of press that you have.) Rotating the brass and running it up into the die multiple times may also essentially do the same thing, but that takes more work and time...</p><p></p><p>Good luck!</p></blockquote><p></p>
[QUOTE="trout004, post: 2748324, member: 119527"] Here are some things that I have done to when I was struggling with the same problems with shoulder runout: 1. Like mentioned above, make sure lubrication is applied in a consistent manner. 2. I have found that inconsistencies or slop in the shell holder can cause this. I have made it a practice to make sure the shell holder is in the same position every time. I run a couple of wraps of electricians tape around them to keep them, securing it to the press ram, clocked in a single position for the entire time that I reload that particular lot (this may or may not work for you depending on the type of press that you have.) Rotating the brass and running it up into the die multiple times may also essentially do the same thing, but that takes more work and time... Good luck! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
FL shoulder bump question
Top