Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Fireform .375 RUM brass for .338 Edge?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="KRP" data-source="post: 216432" data-attributes="member: 9969"><p>How thick you make them depends on how much clearance you want between the neck and the chamber. Some BR guys use .001" clearance(and some don't need to resize necks after firing). .003-.004" would allow a little more room to prevent problems from unforseen circumstances. Factory chambers are usually cut with even more clearance. The less clearance the less the brass is worked during firing, but you need enough to allow proper release of the bullet.</p></blockquote><p></p>
[QUOTE="KRP, post: 216432, member: 9969"] How thick you make them depends on how much clearance you want between the neck and the chamber. Some BR guys use .001" clearance(and some don't need to resize necks after firing). .003-.004" would allow a little more room to prevent problems from unforseen circumstances. Factory chambers are usually cut with even more clearance. The less clearance the less the brass is worked during firing, but you need enough to allow proper release of the bullet. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Fireform .375 RUM brass for .338 Edge?
Top