Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Expander die question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="cajun" data-source="post: 2108140" data-attributes="member: 9772"><p>Measure a loaded round. You want your neck sized about .002 below the loaded round diameter. A lot of guys will use a bushing die about .004 smaller than your desired size then open up the final .002 with the mandrel. If your not turning this will push any neck variance to the outside. I'm guessing you can do the same with the collet die. Some guys swear by them.</p></blockquote><p></p>
[QUOTE="cajun, post: 2108140, member: 9772"] Measure a loaded round. You want your neck sized about .002 below the loaded round diameter. A lot of guys will use a bushing die about .004 smaller than your desired size then open up the final .002 with the mandrel. If your not turning this will push any neck variance to the outside. I’m guessing you can do the same with the collet die. Some guys swear by them. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Expander die question
Top