Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Everyone has done it or will do it. Today was my turn.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="338Rocket" data-source="post: 1290859" data-attributes="member: 96012"><p>I think I would have went 3/32" unless you are planning on going up to #8 screws.</p><p></p><p>1/8" is larger than the drill size for 6-48, and you need to factor in some wobble. I like to use a bit that is just larger than the center of the tap, so it leaves just the flutes behind.</p></blockquote><p></p>
[QUOTE="338Rocket, post: 1290859, member: 96012"] I think I would have went 3/32" unless you are planning on going up to #8 screws. 1/8" is larger than the drill size for 6-48, and you need to factor in some wobble. I like to use a bit that is just larger than the center of the tap, so it leaves just the flutes behind. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Everyone has done it or will do it. Today was my turn.
Top