Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Extreme Long Range Hunting & Shooting (ELR)
ELR reload routine
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="canderson" data-source="post: 904377" data-attributes="member: 10891"><p>I haven't made it to 1500+ but! I have shot several sub MOA groups inside that. I anneal every firing (because I have an annealing machine for f class), bump the shoulders back about 0.002, tumble to remove sizing lube, brush necks, and load. I seat using a Wilson micrometer seater. I found it was easier and produced more concentric ammo for me. I also sort my 338 bullets by bearing surface. It just makes it easier to load a group of rounds to a specific dimension. I would suggest when you get a load close, try 0.1 gr powder either side of your load. Also vary seating depth in and out 0.005 and see if you are getting everything the rifle is capable of delivering. Hope this helps. My edge went from roughly 1/2 MOA to closer to 1/4-1/3 MOA after using the above procedure. My current die is a redding FL. I will use a whidden FL bushing die with same amount of neck tension on my new rifle.</p></blockquote><p></p>
[QUOTE="canderson, post: 904377, member: 10891"] I haven't made it to 1500+ but! I have shot several sub MOA groups inside that. I anneal every firing (because I have an annealing machine for f class), bump the shoulders back about 0.002, tumble to remove sizing lube, brush necks, and load. I seat using a Wilson micrometer seater. I found it was easier and produced more concentric ammo for me. I also sort my 338 bullets by bearing surface. It just makes it easier to load a group of rounds to a specific dimension. I would suggest when you get a load close, try 0.1 gr powder either side of your load. Also vary seating depth in and out 0.005 and see if you are getting everything the rifle is capable of delivering. Hope this helps. My edge went from roughly 1/2 MOA to closer to 1/4-1/3 MOA after using the above procedure. My current die is a redding FL. I will use a whidden FL bushing die with same amount of neck tension on my new rifle. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Extreme Long Range Hunting & Shooting (ELR)
ELR reload routine
Top