Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Easy way to setup a magnetospeed off a barrel
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="JGRJR" data-source="post: 1953361" data-attributes="member: 69912"><p>I have the Sporter model and I only get it to work about 1/3 of the time. It is always a placement issue. But many times it is hard to solve. Modern shooting has a lot of barrel devices, muzzle breaks, flash hiders ect... I can always get it to work with a clean barrel but when is the last time any of us has shot a clean barrel?</p><p>My recent attempt was with a Palma contour barrel and a 419 break. No go. We just could not get the correct alignment.</p><p></p><p>The OP solution separates the alignment from the barrel but would make barrel placement over the sensor very critical. You would have to be very careful to not shoot the sensor. I am going to build my own shim kit. Sometimes you need to straddle a muzzle device and the barrel. So you might need less thickness in front of the mount and more in the back. So having some one inch square rubber shims would be nice.</p></blockquote><p></p>
[QUOTE="JGRJR, post: 1953361, member: 69912"] I have the Sporter model and I only get it to work about 1/3 of the time. It is always a placement issue. But many times it is hard to solve. Modern shooting has a lot of barrel devices, muzzle breaks, flash hiders ect... I can always get it to work with a clean barrel but when is the last time any of us has shot a clean barrel? My recent attempt was with a Palma contour barrel and a 419 break. No go. We just could not get the correct alignment. The OP solution separates the alignment from the barrel but would make barrel placement over the sensor very critical. You would have to be very careful to not shoot the sensor. I am going to build my own shim kit. Sometimes you need to straddle a muzzle device and the barrel. So you might need less thickness in front of the mount and more in the back. So having some one inch square rubber shims would be nice. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Easy way to setup a magnetospeed off a barrel
Top