Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
donuts to go
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Bob Wright" data-source="post: 3008652" data-attributes="member: 104363"><p>Yes, reamers will follow the existing hole. The only way to get a consistent wall is to ream and turn in the same operation. One can expect less than .0002 runout as my measurements have shown. Some variation is most likely non-cleanup if the wall thickness is trying to be maintained to a minimum condition. That could be a result of thin brass necks 'as new'.</p></blockquote><p></p>
[QUOTE="Bob Wright, post: 3008652, member: 104363"] Yes, reamers will follow the existing hole. The only way to get a consistent wall is to ream and turn in the same operation. One can expect less than .0002 runout as my measurements have shown. Some variation is most likely non-cleanup if the wall thickness is trying to be maintained to a minimum condition. That could be a result of thin brass necks 'as new'. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
donuts to go
Top