Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
diy carbon barrel sleeve?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="YAZOO" data-source="post: 1012518" data-attributes="member: 41448"><p>I have done several 10/22 barrels. I turn the front sight boss down to 7/16 and thread to 7/16 NF. Turn barrel from 1" from breech to 7/16" with big radius. Turn breech end of barrel 1/8" down from original dia. leaving a shoulder out 3/4" from breech. Machine aluminum tube to fit over barrel from alum. conduit. Fab SS nut to screw on barrel to tension. Mill 2 flats on muzzle sides to hold barrel while tightening nut. Will shoot as good or better that Vol. barrel.</p></blockquote><p></p>
[QUOTE="YAZOO, post: 1012518, member: 41448"] I have done several 10/22 barrels. I turn the front sight boss down to 7/16 and thread to 7/16 NF. Turn barrel from 1" from breech to 7/16" with big radius. Turn breech end of barrel 1/8" down from original dia. leaving a shoulder out 3/4" from breech. Machine aluminum tube to fit over barrel from alum. conduit. Fab SS nut to screw on barrel to tension. Mill 2 flats on muzzle sides to hold barrel while tightening nut. Will shoot as good or better that Vol. barrel. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
diy carbon barrel sleeve?
Top