Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
CVA question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Nummy" data-source="post: 1751165" data-attributes="member: 111888"><p>Hello - my name is Mark (my screen name is numny)</p><p>You guys seem to know a lot about CVA rifles. I was adjusting to tripper-pull screw on my Acurra Plains rifle, and the screw nearly turned out with zero resistance, so I turned it back to its original position. When I cleaned the barrel I could hear a light metallic rattle, and then a small split-type washer fell out, which I assume was supposed to be attached to the screw. Deer season is just around the corner, and I'm not sure what to do. The trigger works perfectly. Obviously the gun should be sent to CVA, but I can't wait 6 weeks for it to be repaired. What does the tripper adjustment screw push on to?</p><p>If my adjustment screw isn't pushing onto anything, is the trigger's pull weight at the factory minimum of 2.5 lbs?</p><p>Everything seems fine, and the trigger operates like it had when new last fall - do you think I would damage anything if I used it for hunting in two weeks, then send it to CVA during the off-season?</p><p>Thanks for any guidance you can provide !</p></blockquote><p></p>
[QUOTE="Nummy, post: 1751165, member: 111888"] Hello - my name is Mark (my screen name is numny) You guys seem to know a lot about CVA rifles. I was adjusting to tripper-pull screw on my Acurra Plains rifle, and the screw nearly turned out with zero resistance, so I turned it back to its original position. When I cleaned the barrel I could hear a light metallic rattle, and then a small split-type washer fell out, which I assume was supposed to be attached to the screw. Deer season is just around the corner, and I’m not sure what to do. The trigger works perfectly. Obviously the gun should be sent to CVA, but I can’t wait 6 weeks for it to be repaired. What does the tripper adjustment screw push on to? If my adjustment screw isn’t pushing onto anything, is the trigger’s pull weight at the factory minimum of 2.5 lbs? Everything seems fine, and the trigger operates like it had when new last fall - do you think I would damage anything if I used it for hunting in two weeks, then send it to CVA during the off-season? Thanks for any guidance you can provide ! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
CVA question
Top