Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Cutting dovetails, how hard can it be...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Jinx-)" data-source="post: 635333" data-attributes="member: 19791"><p>The oilier on that mill is missing, there are pipes leading to the place were oilier once was, I did asked about the oilier and was told its fine without one, but I didn't buy it... So its ball-screws haven't been oiled since last summer... About toolholder, I have some HSS tools I made, just simple ones like facing, turning, cut-off-parting and 60 degree threading so I was thinking to make holder to fit them first.</p></blockquote><p></p>
[QUOTE="Jinx-), post: 635333, member: 19791"] The oilier on that mill is missing, there are pipes leading to the place were oilier once was, I did asked about the oilier and was told its fine without one, but I didn't buy it... So its ball-screws haven't been oiled since last summer... About toolholder, I have some HSS tools I made, just simple ones like facing, turning, cut-off-parting and 60 degree threading so I was thinking to make holder to fit them first. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Cutting dovetails, how hard can it be...
Top